Comments on: Small drill http://blog.savel.org/2008/03/15/small-drill/ Same chaos as in my room or DIY guide for you. Sun, 14 Mar 2010 16:32:45 +0000 http://wordpress.org/?v=2.9 hourly 1 By: Alex http://blog.savel.org/2008/03/15/small-drill/comment-page-1/#comment-353 Alex Wed, 21 Oct 2009 16:28:56 +0000 http://blog.savel.org/2008/03/15/small-drill/#comment-353 Chineese are clever guys. Many scammers but they like working))) Chineese are clever guys. Many scammers but they like working)))

]]> By: James Thompson http://blog.savel.org/2008/03/15/small-drill/comment-page-1/#comment-206 James Thompson Sat, 22 Mar 2008 19:22:25 +0000 http://blog.savel.org/2008/03/15/small-drill/#comment-206 Good job of tracking down the problem. I may not understand exactly what your problem is so forgive me if I give you information that may not help. I've messed with a few motors before including hand held drills and VCR capstain (speed regulator) motors. Most of the cheap ones (including expensive VCR motors) don't use steel ball bearings to center the rotor shaft, but use a thick brass washer. Sometimes the brass wears out and the shaft can wobble. I've temporarily (sometimes permanently) fixed the wobble by coating the inside of the brass bearing with silver solder. I then reassemble the motor after drilling the center out, or else if the solder was thin enough simply force the shaft back in and manually wiggle the shaft a little to loosen it up. Good job of tracking down the problem. I may not understand exactly what your problem is so forgive me if I give you information that may not help. I’ve messed with a few motors before including hand held drills and VCR capstain (speed regulator) motors. Most of the cheap ones (including expensive VCR motors) don’t use steel ball bearings to center the rotor shaft, but use a thick brass washer. Sometimes the brass wears out and the shaft can wobble. I’ve temporarily (sometimes permanently) fixed the wobble by coating the inside of the brass bearing with silver solder. I then reassemble the motor after drilling the center out, or else if the solder was thin enough simply force the shaft back in and manually wiggle the shaft a little to loosen it up.

]]> By: online casino http://blog.savel.org/2008/03/15/small-drill/comment-page-1/#comment-205 online casino Thu, 20 Mar 2008 16:20:05 +0000 http://blog.savel.org/2008/03/15/small-drill/#comment-205 that looks like a pretty good brand of drills, i guess it works like a charm eh? <em>Thanks, casino-online-best, but your spam is blocked :) -Admin.</em> that looks like a pretty good brand of drills, i guess it works like a charm eh?

Thanks, casino-online-best, but your spam is blocked :) -Admin.

]]>